Precautions for using die-casting molds on machines:

a) Pay attention to the installation direction of the mold. When there is a sliding structure inside the mold, try to open it parallel to the horizontal direction or downwards. Do not place it in the upward opening direction to effectively protect the safety of the side slider and prevent collision with the side core.

b) Before loading and unloading the mold, it is necessary to install anti lock blocks, use main lifting rings, and maintain balance to prevent unnecessary damage.

c) After pressing the mold, remove the anti lock block before opening and closing the mold.

d) After the mold is installed on the die-casting machine, an empty cycle action test is required to check whether the operating mechanism on the mold is flexible and whether the positioning device can effectively function.

e) Adjust the ejection distance. Adjust the position of the ejector mechanism on the die-casting machine in the empty mold state, so that the distance between the mold ejector plate and the movable template limit block is about 5mm.

f) If the mold is equipped with a hydraulic system after the circuit connection, the stroke size should be adjusted, and then the sequential action should be selected to prevent interference between the side core pulling and mold closing actions.